Plik:Usbkey_internals.jpg
Z Wikipedii, wolnej encyclopedia
Rozmiar pierwotny (1000 × 959 pikseli, rozmiar pliku: 490 KB, typ MIME: image/jpeg)
Plik Usbkey internals.jpg znajduje się w Wikimedia Commons – repozytorium wolnych zasobów. Dane z jego strony opisu znajdują się poniżej. |
The internal components of a typical keydrive
This photograph shows both sides of the printed circuit board inside a typical keydrive (Seitec USB-BAR USB 1.1circa 2004), in this case an inexpensive 64 Mbyte USB2.0 device. The plastic clamshell case has been removed.
In practice the keydrive consists of only two significant components. The first is the flash memory part (item 4 in the diagram), a generic device that might as easily be found in a digital camera's memory card. The second (item 2 in the diagram) is a device which implements the USB networking and mass-storage interface, and which knows how to make a chunk of generic flash memory appear like a normal disk drive. The high degree of integration in this latter part makes small, inexpensive keydrives possible.
The parts of the device are as follows:
- A male type-A USB connector.
- An Ours Technology Inc. OTi-2168 USB 2.0 mass storage controller. This implements the USB 2.0 host controller, and provides a seamless linear interface to block-oriented serial flash devices, while hiding the complexities of block-orientation, block erasure, and wear balancing. It contains a small RISC microprocessor and a small amount of ROM and RAM. This communicates with the Hynix device over an 8-line unified address/data bus. This version is a 7x7mm 48-pin LQFP (Low Profile Quad Flat Pack) surface-mount device (info).
- JP1 and JP2: two unpopulated 10-pin connectors, used for testing during the keydrive's manufacture.
- A Hynix Semiconductor HY27USxx121M series NAND Flash memory device, featuring 4096 independently erasable blocks each providing 16 Kbytes of storage, yielding a total of 64 Mbytes of usable storage. The version used in this keydrive is a 20x12mm 48-pin TSOP1 (Thin Small Outline Package) surface-mount package (datasheet) archive copy at the Wayback Machine.
- An SKC Shin Chang Electronics 12.000 MHz crystal oscillator (XTAL). The OTi device runs the output of this through a phase-locked loop to produce its main 12 MHz clock signal.
- A single yellow light-emitting diode (run from a pin on the OTi device) which flashes to indicate activity.
- A simple two-position switch, used to indicate whether the device should be in "write-protect" mode. It is shown here in the make position, indicating write-protect is off.
- An unpopulated space for a second TSOP1 memory package. The OTi device is capable of driving up to eight such devices. Having this second space allows the manufacturer to choose (generally on a cost basis) whether to use one or two TSOP flash parts.
Surrounding these main components are a number of tiny surface-mount resistors (many of them serving as pull-ups) and capacitors.
For a closeup of an area of this keydrive, see this image.
Information and licensing
Photographs taken and annotated by John Fader in December 2004 using Adobe Photoshop and Inkscape. This image is (C) Copyright 2004 and (with the exception of its use under the GFDL) all rights are reserved.
Udziela się zgody na kopiowanie, rozpowszechnianie oraz modyfikowanie tego dokumentu zgodnie z warunkami GNU Licencji Wolnej Dokumentacji, w wersji 1.2 lub nowszej opublikowanej przez Free Software Foundation; bez niezmiennych sekcji, bez treści umieszczonych na frontowej lub tylnej stronie okładki. Kopia licencji załączona jest w sekcji zatytułowanej GNU Licencja Wolnej Dokumentacji.http://www.gnu.org/copyleft/fdl.htmlGFDLGNU Free Documentation Licensetruetrue |
Ten plik udostępniony jest na licencji Creative Commons Uznanie autorstwa – Na tych samych warunkach 3.0. | ||
| ||
Ten szablon został dodany jako element zmiany licencjonowania.http://creativecommons.org/licenses/by-sa/3.0/CC BY-SA 3.0Creative Commons Attribution-Share Alike 3.0truetrue |
Originally uploaded by John Fader 17:59, 4 December 2004
Obiekty przedstawione na tym zdjęciu
przedstawia
Historia pliku
Kliknij na datę/czas, aby zobaczyć, jak plik wyglądał w tym czasie.
Data i czas | Miniatura | Wymiary | Użytkownik | Opis | |
---|---|---|---|---|---|
aktualny | 13:23, 7 lip 2008 | 1000 × 959 (490 KB) | Samulili | better | |
15:43, 5 kwi 2008 | 1000 × 902 (219 KB) | Talgraf777 | {{Information |Description= |Source= |Date= |Author= |Permission= |other_versions= }} | ||
21:32, 18 lip 2005 | 1000 × 959 (490 KB) | Solipsist~commonswiki | ==The internal components of a typical keydrive== This photograph shows both sides of the printed circuit board inside a typical keydrive (circa 2004), in this case an inexpensive 64 Mbyte USB2.0 device. The plastic clamshell case has been remov |
Lokalne wykorzystanie pliku
Następujące strony korzystają z tego pliku:
Globalne wykorzystanie pliku
Ten plik jest wykorzystywany także w innych projektach wiki:
- Wykorzystanie na af.wikipedia.org
- Wykorzystanie na ar.wikipedia.org
- Wykorzystanie na az.wikipedia.org
- Wykorzystanie na ba.wikipedia.org
- Wykorzystanie na bg.wikipedia.org
- Wykorzystanie na bn.wikipedia.org
- Wykorzystanie na bs.wikipedia.org
- Wykorzystanie na ca.wikipedia.org
- Wykorzystanie na cs.wikipedia.org
- Wykorzystanie na da.wikipedia.org
- Wykorzystanie na el.wikipedia.org
- Wykorzystanie na en.wikipedia.org
- USB flash drive
- File talk:Usbkey internals.jpg
- User talk:John Fader
- Wikipedia:Picture of the day/July 2005
- Wikipedia:Featured picture candidates/May-2005
- Wikipedia:Featured picture candidates/Usbkey internals.jpg
- Wikipedia:Wikipedia Signpost/2005-05-30/Features and admins
- Wikipedia:Today's second feature/July 2005
- Wikipedia:Picture of the day/July 31, 2005
- Wikipedia:POTD/July 31, 2005
- Wikipedia:Today's second feature/July 31, 2005
- User:Cyde/Featured pictures
- User talk:Deltabeignet/Archive01
- Talk:Maxwell's equations/Archive 2
- Portal:Electronics/Selected picture
- Wikipedia:Featured picture candidates/delist/2007
- Portal:Electronics/Selected picture/2
- Wikipedia:Featured picture candidates/delist/USB flash drive
- Wikipedia:Wikipedia Signpost/Single/2005-05-30
- Wykorzystanie na en.wikibooks.org
- A-level Computing 2009/AQA/Computer Components, The Stored Program Concept and the Internet/Hardware Devices/Secondary storage devices
- A-level Computing 2009/AQA/Print version/Unit 2
- A-level Computing/AQA/Computer Components, The Stored Program Concept and the Internet/Hardware Devices/Secondary storage devices
- A-level Computing/AQA/Print version/Unit 2
- A-level Computing/AQA/Paper 2/External hardware devices/Secondary storage devices
- Wykorzystanie na es.wikipedia.org
- Wykorzystanie na es.wikibooks.org
- Wykorzystanie na et.wikipedia.org
- Wykorzystanie na eu.wikipedia.org
- Wykorzystanie na fa.wikipedia.org
- Wykorzystanie na fi.wikipedia.org
- Wykorzystanie na fr.wikipedia.org
- Wykorzystanie na fr.wikibooks.org
- Wykorzystanie na gl.wikipedia.org
- Wykorzystanie na he.wikipedia.org
- Wykorzystanie na hi.wikipedia.org
- Wykorzystanie na hu.wikipedia.org
Pokaż listę globalnego wykorzystania tego pliku.
Metadane
Niniejszy plik zawiera dodatkowe informacje, prawdopodobnie dodane przez aparat cyfrowy lub skaner użyte do wygenerowania tego pliku.
Jeśli plik był modyfikowany, dane mogą być częściowo niezgodne z parametrami zmodyfikowanego pliku.
Orientacja obrazu | normalna |
---|---|
Rozdzielczość w poziomie | 72 punktów na cal |
Rozdzielczość w pionie | 72 punktów na cal |
Użyte oprogramowanie | Adobe Photoshop 7.0 |
Data i czas modyfikacji pliku | 16:51, 4 gru 2004 |
Przestrzeń kolorów | Nie skalibrowano |